Assembled and installed the horizontal stab and elevator on to the fuselage. Connected the trim motor and tested it through the full range of nose up/nose down with no issues. Installed and riveted one side of the flaperon hinges on both wings. I'll do the other side once I install the flaperons themselves just to be sure they are all aligned (they were when I test fit them last year but you never know. Started looking at the glare shield install and saw where one builder suggested making the clips a little longer making it easier to get the glare shield to engage them. I had already built the clips to the specs in the manual but decided that making them a little longer made some sense. So I fabricated them to be a quarter inch longer after the bend.